DOI QR코드

DOI QR Code

Predictive models of ultimate and serviceability performances for underground twin caverns

  • Zhang, Wengang (Key Laboratory of New Technology for Construction of Cities in Mountain Area (Chongqing University), Ministry of Education) ;
  • Goh, Anthony T.C. (School of Civil and Environmental Engineering, Nanyang Technological University)
  • 투고 : 2014.12.12
  • 심사 : 2015.12.08
  • 발행 : 2016.02.25

초록

The construction of a new cavern modifies the state of stresses and displacements in a zone around the existing cavern. For multiple caverns, the size of this influence zone depends on the ground type, the in situ stress, the cavern span and shape, the width of the pillar separating the caverns, and the excavation sequence. Performances of underground twin caverns can be unsatisfactory as a result of either instability (collapse) or excessive displacements. These two distinct failures should be prevented in design. This study simulated the ultimate and serviceability performances of underground twin rock caverns of various sizes and shapes. The global factor of safety is used as the criterion for determining the ultimate limit state and the calculated maximum displacement around the cavern opening is adopted as the serviceability limit state criterion. Based on the results of a series of numerical simulations, simple regression models were developed for estimating the global factor of safety and the maximum displacement, respectively. It was proposed that a proper pillar width can be determined based on the threshold influence factor value. In addition, design charts with regard to the selection of the pillar width for underground twin rock caverns under similar ground conditions were also developed.

키워드

참고문헌

  1. Adoko, A.C., Jiao, Y.Y., Wu, L., Wang, H. and Wang, Z.H. (2013), "Predicting tunnel convergence using Multivariate Adaptive Regression Spline and Artificial Neural Network", Tunn. Undergr. Space Technol., 38, 368-376. https://doi.org/10.1016/j.tust.2013.07.023
  2. Barla, G. and Ottoviani, M. (1974), "Stresses and displacements around two adjacent circular openings near to the ground surface", Proceedings of the 3rd International Congress on Rock Mechanics, National Academy of Sciences, Denver, CO, USA, September, pp. 975-980.
  3. Basarir, H. (2008), "Analysis of rock-support interaction using numerical and multiple regression modeling", Can. Geotech. J., 45(1), 1-13. https://doi.org/10.1139/T07-053
  4. Bieniawski, Z.T. (1978), "Determining rock mass deformability: experience from case histories", Int. J. Rock Mech. Min. Sci. Geomech. Abstr., 15(5), 237-247. https://doi.org/10.1016/0148-9062(78)90956-7
  5. Bieniawski, Z.T. (1989), Engineering Rock Mass Classifications, John Wiley and Sons, New York, USA.
  6. Dawson, E.M., Roth, W.H. and Drescher, A. (1999), "Slope stability analysis by strength reduction", Geotechnique, 49(6), 835-840. https://doi.org/10.1680/geot.1999.49.6.835
  7. Dawson, E.M., Motamed, F., Nesarajah, S. and Roth, W.H. (2000), "Geotechnical stability analysis by strength reduction", Proceedings of Sessions of Geo-Denver 2000-Slope Stability, 289, 99-113.
  8. Esterhuizen, G.S., Dolinar, D.R. and Ellenberger, J.L. (2011), "Pillar strength in underground stone mines in the United States", Int. J. Rock Mech. Min. Sci., 48(1), 42-50. https://doi.org/10.1016/j.ijrmms.2010.06.003
  9. Gercek, H. (2005), "Interaction between parallel underground openings", Proceedings of the 19th International Mining Congress and Fair of Turkey, IMCEV2005, Izmir, Turkey, pp. 73-81.
  10. Ghaboussi, J. and Ranken, R.E. (1977), "Interaction between two parallel tunnels", Int. J. Numer. Anal. Meth. Geomech., 1(1), 75-103. https://doi.org/10.1002/nag.1610010107
  11. Goh, A.T.C. and Zhang, W.G. (2012), "Reliability assessment of stability of underground rock caverns", Int. J. Rock Mech. Min. Sci., 55, 157-163.
  12. Hammah, R.E., Yacoub, T. and Curran, J.H. (2007), "Serviceability-based slope factor of safety using the shear strength reduction (SSR) method", Proceedings of the 11th Congress of the International Society for Rock Mechanics, Lisbon, Portugal, July, pp. 1137-1140.
  13. Jiao, Y.Y., Song, L., Wang, X.Z. and Adoko, A.C. (2013a), "Improvement of the U-shaped steel sets for supporting the roadways in loose coal seam", Int. J. Rock Mech. Min. Sci., 60, 19-25.
  14. Jiao, Y.Y., Wang, Z.H., Wang, X.Z., Adoko, A.C. and Yang, Z.X. (2013b), "Stability assessment of an ancient landslide crossed by two coal mine tunnels", Eng. Geol., 159, 36-44. https://doi.org/10.1016/j.enggeo.2013.03.021
  15. Jiao, Y.Y., Tian, H.N., Liu, Y.Z., Mei, R.W. and Li, H.B. (2015), "Prediction of tunneling hazardous geological zones using the active seismic approach". Near Surf. Geophys., 13(4), 333-342.
  16. Karademir, S.M. (2010), "A parametric study on three dimensional modeling of parallel tunnel interactions", Ph.D. Thesis; Middle East Technical University, Ankara, Turkey.
  17. Li, S.J., Feng, X.T. and Li, Z.H. (2012), "Evolution of fractures in the excavation damaged zone of a deeply buried tunnel during TBM construction", Int. J. Rock Mech. Min. Sci., 55, 125-138.
  18. Lu, Q., Chan, C.L. and Low, B.K. (2012), "Probabilistic evaluation of ground-support interaction for deep rock excavation using artificial neural network and uniform design", Tunn. Undergr. Space Technol., 32, 1-18. https://doi.org/10.1016/j.tust.2012.04.014
  19. Mahdevari, S. and Torabi, S.R. (2012), "Prediction of tunnel convergence using Artificial Neural Networks", Tunn. Undergr. Space Technol., 28, 218-228. https://doi.org/10.1016/j.tust.2011.11.002
  20. Matsui, T. and San, K.C. (1992), "Finite element slope stability analysis by shear strength reduction technique", Soil. Found., 32(1), 59-70. https://doi.org/10.3208/sandf1972.32.59
  21. Mortazavi, A., Hassani, F.P. and Shabani, M. (2009), "A numerical investigation of rock pillar failure mechanism in underground openings", Comput. Geotech., 36(5), 691-697. https://doi.org/10.1016/j.compgeo.2008.11.004
  22. Palmstrom, A. (2000), "On classification systems", Proceedings GeoEng2000, Melbourne, Australia, November.
  23. Rafiai, H. and Moosavi, M. (2012), "An approximate ANN-based solution for convergence of lined circular tunnels in elasto-plastic rock masses with anisotropic stresses", Tunn. Undergr. Space Technol., 27(1), 52-59. https://doi.org/10.1016/j.tust.2011.06.008
  24. Serafim, J.L. and Pereira, J.P. (1983), "Considerations of the geomechanics classification of Bieniawski", Proceedings of the International Symposium on Engineering Geology and Underground Construction, Volume 1, Rotterdam, The Netherlands, month, pp. 1133-1142.
  25. Siahmansouri, A., Gholamnejad, J. and Marji, M.F. (2012), "A new method to predict ratio of width to height rock pillar in twin circular tunnels", J. Geol. Geosci., 1, 103. DOI: 10.4172/2329-6755.1000103
  26. Tugrul, A. (1998), "The application of rock mass classification systems to underground excavation in weak lime stone, Ataturk dam", Turkey Eng. Geol., 50(3-4), 337-345. https://doi.org/10.1016/S0013-7952(98)00034-9
  27. Vermeer, P.A., Ruse, N. and Marcher, T. (2002), "Tunneling heading stability in drained ground", Felsbau 20(6), 8-18.
  28. Zhang, W.G. and Goh, A.T.C. (2012), "Reliability assessment on ultimate and serviceability limit states and determination of critical factor of safety for underground rock caverns", Tunn. Undergr. Space Technol., 32, 221-230. https://doi.org/10.1016/j.tust.2012.07.002
  29. Zhang, W.G. and Goh, A.T.C. (2013), "Multivariate adaptive regression splines for analysis of geotechnical engineering systems", Comput. Geotech., 48, 82-95. https://doi.org/10.1016/j.compgeo.2012.09.016
  30. Zhao, B.Y. and Ma, Z.Y. (2009), "Influence of cavern spacing on the stability of large cavern groups in a hydraulic power station", Int. J. Rock Mech. Min. Sci., 46(3), 506-513. https://doi.org/10.1016/j.ijrmms.2008.10.002
  31. Zhu, W.S., Sui, B., Li, X.J., Li, S.C. and Wang, W.T. (2008), "A methodology for studying the high wall displacement of large scale underground cavern complexes and its applications", Tunn. Undergr. Space Technol., 23(6), 651-664. https://doi.org/10.1016/j.tust.2007.12.009

피인용 문헌

  1. Reliability analysis of shallow tunnels using the response surface methodology vol.2, pp.4, 2017, https://doi.org/10.1016/j.undsp.2017.11.003
  2. Simple solutions of an opening in elastic-brittle plastic rock mass by total strain and incremental approaches vol.13, pp.4, 2016, https://doi.org/10.12989/gae.2017.13.4.585
  3. A systematic review and meta-analysis of artificial neural network application in geotechnical engineering: theory and applications vol.32, pp.2, 2016, https://doi.org/10.1007/s00521-019-04109-9
  4. Studying the deformation and stability of rock mass surrounding the power station caverns using NA and GEP models vol.79, pp.1, 2016, https://doi.org/10.12989/sem.2021.79.1.035