DOI QR코드

DOI QR Code

Bearing Strength of Filler Joint in EG-Frame System for the Construction of Underground Wall in Building

건물 지하벽 시공을 위한 EG-Frame 시스템의 필러 연결부 지압강도

  • 서수연 (한국교통대학교 건축공학과) ;
  • 김강수 (서울시립대학교 건축학부)
  • Received : 2016.03.07
  • Accepted : 2016.10.24
  • Published : 2016.10.30

Abstract

The objective of this paper is to evaluate the structural safety of EG-Frame system resisting the earth pressure from CIP (Cast-in Place Pile). To accomplish the objective, a compression experiment and FE (Finite Element) analysis for the filler joint in EG-Frame were performed and suggested a proper design process. In the experiment, parameters are the width of the composite beam and the size of bearing plate. In FE analysis, total strain crack model was used for the modeling the concrete in the composite beam and CIP. the joint of CIP and composite beam was modeled as a perfect bond condition. From the experiment, it was shown that a separation of concrete composite beam appeared after shear failure when the width increased. The compressive strength depended on the size of bearing plate. However, there was not a trend of stiffness variation even if the size of bearing plate increased. In the case of same bearing plate, the strength decreased corresponding to the increase of width of the composite beam. It is thought that the round shape of CIP contributed the increase of the shear slip between the contact surfaces of the composite beam and CIP when the width increased.

Keywords

Acknowledgement

Supported by : 한국건설기술연구원

References

  1. Architectural Institute of Korea (2009), Korean Building Code and Commentary, 330-331
  2. Lee, L. (2001), Development of SPS System and Evaluation of Structural Capacity, Research report, STRESS center at Hanyang University.
  3. Midas Information Technology (2015), Midas-FEA, Advanced Nonlinear and Detail Analysis System
  4. Seo, S. (2012), Evaluation on the Structural Capacity and Water Permeability of EG-Frame-C System, Research report, Korea National University of Transportation.
  5. Thorenfeldt, E., Tomaszewicz, A., & Jensen, J. (1987), Mechanical properties of high strength concrete and application in design. Proceedings of the Symposium on Utilization of High Strength Concrete, Tapir, Trondheim, Norway, pp. 149-159