DOI QR코드

DOI QR Code

Influence of undercut and surface crack on the stability of a vertical escarpment

  • Banerjee, Sounik K. (School of Civil Engineering, Kalinga Institute of Industrial Technology) ;
  • Chakraborty, Debarghya (Department of Civil Engineering, Indian Institute of Technology Kharagpur)
  • Received : 2016.04.20
  • Accepted : 2017.01.17
  • Published : 2017.06.25

Abstract

Stability of vertical escarpments has been the subject of discussion for long time. However, available literature provides scarce knowledge about the effect of the formation of undercut and surface cracks on the stability of a vertical escarpment. The present study deals with a systematic analysis of the effect of surface cracks and undercut on slope stability using finite element based lower bound limit analysis. In the present analysis, the non-dimensional stability factor (${\gamma}H/c$) is used to inspect the degrading effect of undercut and cracks developed at different offset distances from the edge of the vertical escarpment. Failure patterns are also studied in detail to understand the extent and the type of failure zone which may generate during the state of collapse.

Keywords

References

  1. Abderahman, P. (2007), "Evaluating the influence of rate of undercutting on the stability of slopes", Bull. Eng. Geol. Environ., 66(3), 303-309. https://doi.org/10.1007/s10064-006-0078-6
  2. Bekaert, P. (1995), "Improvement of the kinematic bound for the stability of a vertical cut-off", Mech. Res. Commun., 22(6), 533-540. https://doi.org/10.1016/0093-6413(95)00058-5
  3. Bottero, A., Negre, R., Pastor, J. and Turgeman, S. (1980), "Finite element method and limit analysis theory for soil mechanics problem", Comput. Method. Appl. Mech. Eng., 22(1), 131-149. https://doi.org/10.1016/0045-7825(80)90055-9
  4. Chakraborty, D. and Kumar, J. (2013a), "Stability of a long unsupported circular tunnel in soils with seismic forces", Natural Hazards, 68(2), 419-431. https://doi.org/10.1007/s11069-013-0633-y
  5. Chakraborty, D. and Kumar, J. (2013b), "Bearing capacity of circular footings on reinforced soils", Int. J. Geomech., ASCE, 15(1), 1-9.
  6. Chen, W.F., Giger, M.W. and Fang, H.Y. (1969), "On the limit analysis of stability of slopes", Soils Found., 9(4), 23-32. https://doi.org/10.3208/sandf1960.9.4_23
  7. Chu-Agor, M.L., Wilson, G.V. and Fox, G.A. (2014), "Numerical modeling of bank instability by seepage erosion undercutting of layered stream-banks", J. Hydrol. Eng., ASCE, 13(12), 1133-1145. https://doi.org/10.1061/(ASCE)1084-0699(2008)13:12(1133)
  8. Davis, E.H. and Booker, J.R. (1973), "The effect of increasing strength with depth on the bearing capacity of clays", Geotechnique, 23(4), 551-563. https://doi.org/10.1680/geot.1973.23.4.551
  9. Florkiewicz, A. and Kubzdela, A. (2013), "Factor of safety in limit analysis of slopes", Geomech. Eng., Int. J., 5(5), 485-497. https://doi.org/10.12989/gae.2013.5.5.485
  10. Gao, Y., Wu, D., Zhang, F., Lei, G.H., Qin, H. and Qiu, Y. (2016), "Limit analysis of 3D rock slope stability with non-linear failure criterion", Geomech. Eng., Int. J., 10(1), 59-76. https://doi.org/10.12989/gae.2016.10.1.059
  11. Liu, D. and Chen, X. (2015), "Shearing characteristics of slip zone soils and strain localization analysis of a landslide", Geomech. Eng., Int. J., 8(1), 33-52. https://doi.org/10.12989/gae.2015.8.1.033
  12. Lysmer, J. (1970), "Limit analysis of plane problems in soil mechanics", J. Soil Mech. Found. Div., ASCE, 96(4), 1311-1333.
  13. Michalowski, R.L. (2002), "Stability charts for uniform slopes", J. Geotech. Geoenviron. Eng., ASCE, 128(4), 351-355. https://doi.org/10.1061/(ASCE)1090-0241(2002)128:4(351)
  14. Michalowski, R.L. (2012), "Stability assessment of slopes with cracks", Proceedings of Geo-Congress, Oakland, CA, USA, March, pp. 442-450.
  15. Michalowski, R.L. (2013), "Stability assessment of slopes with cracks using limit analysis", Can. Geotech. J., 50(10), 1011-1021. https://doi.org/10.1139/cgj-2012-0448
  16. Miscevic, A. and Vlastelica, G. (2014), "Impact of weathering on slope stability in soft rock mass", J. Rock Mech. Geotech. Eng., 6(3), 240-250. https://doi.org/10.1016/j.jrmge.2014.03.006
  17. Poulos, H.G. and Davis, E.H. (1980), Pile Foundation Analysis and Design, Wiley, NewYork, NY, USA.
  18. Sloan, S.W. (1988), "Lower bound limit analysis using finite-elements and linear programming", Int. J. Numer. Anal. Method. Geomech., 12(1), 61-77. https://doi.org/10.1002/nag.1610120105
  19. Sloan, S.W. and Kleeman, P.W. (1995), "Upper bound limit analysis with discontinuous velocity fields", Comput. Method. Appl. Mech. Eng., 127(1-4), 293-314. https://doi.org/10.1016/0045-7825(95)00868-1
  20. Taylor, D.W. (1937), "Stability of earth slopes", J. Boston Soc. Civil Eng., 24(3), 197-246.
  21. Tsesarsky, M., Hatzor, Y.H., Leviathan, I., Saltzman, U. and Sokolowksy, M. (2005), "Structural control on the stability of overhanging, discontinuous rock slopes", Am. Rock Mech. Assoc., 5, 771-781.
  22. Yang, X.L. and Pan, Q.J. (2015), "Three dimensional seismic and static stability of rock slopes", Geomech. Eng., Int. J., 8(1), 97-111. https://doi.org/10.12989/gae.2015.8.1.097
  23. Zhang, F., Liu, G., Chen, W., Liang, S., Chen, R. and Han, W. (2012), "Human-induced landslide on a high cut slope: a case of repeated failures due to multi-excavation", J. Rock Mech. Geotech. Eng., 4(4), 367-374. https://doi.org/10.3724/SP.J.1235.2012.00367
  24. Zhao, C. (2015), "Analytical solutions for crack initiation on floor-strata interface during mining", Geomech. Eng., Int. J., 8(2), 237-255. https://doi.org/10.12989/gae.2015.8.2.237