DOI QR코드

DOI QR Code

Comparative study on dynamic properties of argillaceous siltstone and its grouting-reinforced body

  • Huang, Ming (College of Civil Engineering, Fuzhou University) ;
  • Xu, Chao-Shui (School of Civil, Environment and Mining Engineering, the University of Adelaide) ;
  • Zhan, Jin-Wu (College of Civil Engineering, Fuzhou University) ;
  • Wang, Jun-Bao (School of Civil Engineering, Xi'an University of Architecture and Technology)
  • 투고 : 2016.06.01
  • 심사 : 2017.03.15
  • 발행 : 2017.08.25

초록

A comparison study is made between the dynamic properties of an argillaceous siltstone and its grouting-reinforced body. The purpose is to investigate how grout injection can help repair broken soft rocks. A slightly weathered argillaceous siltstone is selected, and part of the siltstone is mechanically crushed and cemented with Portland cement to simulate the grouting-reinforced body. Core specimens with the size of $50mm{\times}38mm$ are prepared from the original rock and the grouting-reinforced body. Impact tests on these samples are then carried out using a Split Hopkinson Pressure Bar (SHPB) apparatus. Failure patterns are analyzed and geotechnical parameters of the specimens are estimated. Based on the experimental results, for the grouting-reinforced body, its shock resistance is poorer than that of the original rock, and most cracks happen in the cementation boundaries between the cement mortar and the original rock particles. It was observed that the grouting-reinforced body ends up with more fragmented residues, most of them have larger fractal dimensions, and its dynamic strength is generally lower. The mass ratio of broken rocks to cement has a significant effect on its dynamic properties and there is an optimal ratio that the maximum dynamic peak strength can be achieved. The dynamic strain-softening behavior of the grouting-reinforced body is more significant compared with that of the original rock. Both the time dependent damage model and the modified overstress damage model are equally applicable to the original rock, but the former performs much better compared with the latter for the grouting-reinforced body. In addition, it was also shown that water content and impact velocity both have significant effect on dynamic properties of the original rock and its grouting-reinforced body. Higher water content leads to more small broken rock pieces, larger fractal dimensions, lower dynamic peak strength and smaller elastic modulus. However, the water content plays a minor role in fractal dimensions when the impact velocity is beyond a certain value. Higher impact loading rate leads to higher degree of fragmentation and larger fractal dimensions both in argillaceous siltstone and its grouting-reinforced body. These results provide a sound basis for the quantitative evaluation on how cement grouting can contribute to the repair of broken soft rocks.

키워드

과제정보

연구 과제 주관 기관 : National Natural Science Foundation of China, Natural Science Foundation of Fujian province

참고문헌

  1. Bailly, P., Delvare, F., Vial, J., Hanus, J.L., Biessy, M. and Picart, D. (2011), "Dynamic behavior of an aggregate material at simultaneous high pressure and strain rate: SHPB triaxial tests", Int. J. Impact Eng., 38(2-3), 73-84. https://doi.org/10.1016/j.ijimpeng.2010.10.005
  2. Chen, J., Du, C., Jiang, D., Fan, J. and He, Y. (2016), "The mechanical properties of rock salt under cyclic loading-unloading experiments", Geomech. Eng., Int. J., 10(3), 325-334. https://doi.org/10.12989/gae.2016.10.3.325
  3. Dai, F., Huang, S., Xia, K. and Tan, Z. (2010), "Some fundamental issues in dynamic compression and tension tests of rocks using split Hopkinson pressure bar", Rock Mech. Rock Eng., 43(6), 657-666. https://doi.org/10.1007/s00603-010-0091-8
  4. Di, Q. and Wang, M. (2010), "Determining areas of leakage in the Da Ye Dam using multi-electrode resistivity", Bull. Eng. Geol. Environ., 69(1), 105-119. https://doi.org/10.1007/s10064-009-0222-1
  5. Dong, Z.X. and Shan, R.L. (1999), "Study of constitutive properties of rocks under high strain rates", Eng. Blast., 5(2), 5-9.
  6. Erguler, Z.A. and Ulusay, R. (2009), "Water-induced variations in mechanical properties of clay-bearing rocks", Int. J. Rock Mech. Min. Sci., 46(2), 355-370. https://doi.org/10.1016/j.ijrmms.2008.07.002
  7. Ghanbarian, B. and Daigle, H. (2015), "Fractal dimension of soil fragment mass-size distribution: A critical analysis", Geoderma, 245(5), 98-103.
  8. Hsiao, D.H., Phan, V.T.A. and Huang, C.C. (2016), "An experimental investigation on dynamic properties of various grouted sands", Geomech. Eng., Int. J., 10(1), 77-94. https://doi.org/10.12989/gae.2016.10.1.077
  9. Jiang, F. and Vecchio, K.S. (2009), "Hopkinson bar loaded fracture experimental technique: a critical review of dynamic fracture toughness tests", Appl. Mech. Rev., 62(6), 1469-1474.
  10. Kikuchi, K., Igari, T., Mito, Y. and Utsuki, S. (1997), "In situ experimental studies on improvement of rock masses by grouting treatment", Int. J. Rock Mech. Min. Sci., 34(3-4), 138.e1-138.e14.
  11. Li, X. and Tao, M. (2015), "The influence of initial stress on wave propagation and dynamic elastic coefficients", Geomech. Eng., Int. J., 8(3), 377-390. https://doi.org/10.12989/gae.2015.8.3.377
  12. Li, W. and Wu, Q. (2013), "Grout improvement effect in jointed rock slope by numerical modelling method", Electron. J. Geotech. Eng., 18, 259-268.
  13. Li, W. and Xu, J. (2009), "Impact characterization of basalt fiber reinforced geopolymeric concrete using a 100 mm-diameter split Hopkinson pressure bar", Mater. Sci. Eng. A, 513(5), 145-153.
  14. Liu, Y.R. and Tang, H.M. (1999), Rock Mechanics, China University of Geosciences Press, Beijing, China
  15. Liu, X.H., Zhang, R. and Liu, J.F. (2012), "Dynamic test study of coal rock under different strain rates", J. China Coal Soc., 37(9), 1528-1534. [In Chinese]
  16. Lu, Y.B., Li, Q.M. and Ma, G.W. (2010), "Numerical investigation of the dynamic compressive strength of rocks based on split Hopkinson pressure bar tests", International Journal of Rock Mechanics and Mining Sciences, 47(5), 829-838. https://doi.org/10.1016/j.ijrmms.2010.03.013
  17. Nolen-Hoeksema, R.C. and Gordon, R.B. (1987), "Optical detection of crack patterns in the opening-mode fracture of marble", Int. J. Rock Mech. Min. Sci. Geomech. Abstr., 24(2), 135-144. https://doi.org/10.1016/0148-9062(87)91933-4
  18. Shan, R., Jiang, Y. and Li, B. (2000), "Obtaining dynamic complete stress-strain curves for rock using the Split Hopkinson Pressure Bar technique", Int. J. Rock Mech. Min. Sci., 37(6), 983-992. https://doi.org/10.1016/S1365-1609(00)00031-9
  19. Shan, R.L., Xue, Y.S. and Zhang, Q. (2003), "Time dependent damage model of rock under dynamic loading", Chinese J. Rock Mech. Eng., 22(11), 1771-1776. [In Chinese]
  20. Utsuki, S. (2013), "In-situ experimental studies on improvement of deformability of rock masses by grout treatment", Int. J. JCRM, 9(1), 7-8.
  21. Wang, Q.Z., Zhang, S. and Xie, H.P. (2010), "Rock dynamic fracture toughness tested with holed-cracked flattened Brazilian discs diametrically impacted by SHPB and its size effect", Experim. Mech., 50(7), 877-885. https://doi.org/10.1007/s11340-009-9265-2
  22. Wong, R.H. and Chau, K.T. (1998), "Crack coalescence in a rock-like material containing two cracks", Int. J. Rock Mech. Min. Sci., 35(2), 147-164. https://doi.org/10.1016/S0148-9062(97)00303-3
  23. Xie, H.P. (1993), Fractals in Rock Mechanics, CRC Press, Beijing, China.
  24. Xu, H.F., Geng, H.S., Li, C.F., Chen, W. and Wang, C. (2013), "Estimating strength of grouting reinforced bodies in broken rock mass", Chinese J. Geotech. Eng., 35(11), 2018-2022. [In Chinese]
  25. Yang, X. and Li, Y. (2008), "Construction and quality analysis of curtain grouting in foundation of dam for Yangtze Three Gorges Project", J. Child Family Studies, 18(6), 978-981.
  26. Zhang, M., Wu, H.J., Li, Q.M. and Huang, F.L. (2009), "Further investigation on the dynamic compressive strength enhancement of concrete-like materials based on split Hopkinson pressure bar tests. Part I: Experiments", Int. J. Impact Eng., 36(12), 1327-1334. https://doi.org/10.1016/j.ijimpeng.2009.04.009
  27. Zhao, G., Xie, L. and Meng, X. (2014), "A damage-based constitutive model for rock under impacting load", Int. J. Min. Sci. Technol., 24(4), 505-511. https://doi.org/10.1016/j.ijmst.2014.05.014
  28. Zhou, Z., Li, X., Liu, A. and Zou, Y. (2011), "Stress uniformity of split Hopkinson pressure bar under halfsine wave loads", Int. J. Rock Mech. Min. Sci., 48(4), 697-701. https://doi.org/10.1016/j.ijrmms.2010.09.006
  29. Zolfaghari, A., Bidar, A.S., Javan, M.M., Haftani, M. and Mehinrad, A. (2015), "Evaluation of rock mass improvement due to cement grouting by Q-system at Bakhtiary dam site", Int. J. Rock Mech. Min. Sci., 74(2), 38-44.