DOI QR코드

DOI QR Code

Investigation lateral deformation and failure characteristics of strip coal pillar in deep mining

  • Chen, Shaojie (State Key Laboratory of Mining Disaster Prevention and Control, Shandong University of Science and Technology) ;
  • Qu, Xiao (State Key Laboratory of Mining Disaster Prevention and Control, Shandong University of Science and Technology) ;
  • Yin, Dawei (State Key Laboratory of Mining Disaster Prevention and Control, Shandong University of Science and Technology) ;
  • Liu, Xingquan (State Key Laboratory of Mining Disaster Prevention and Control, Shandong University of Science and Technology) ;
  • Ma, Hongfa (State Key Laboratory of Mining Disaster Prevention and Control, Shandong University of Science and Technology) ;
  • Wang, Huaiyuan (State Key Laboratory of Mining Disaster Prevention and Control, Shandong University of Science and Technology)
  • 투고 : 2016.10.16
  • 심사 : 2017.09.03
  • 발행 : 2018.04.10

초록

In deep mining, the lateral deformation of strip coal pillar appears to be a new characteristic. In order to study the lateral deformation of coal-mass, a monitoring method and monitoring instrument were designed to investigate the lateral deformation of strip coal pillar in Tangkou Coalmine with the mining depth of over 1000 m. Because of without influence of repeated mining, the bedding sandstone roof is easy to break and the angle between maximum horizontal stress and the roadway is small, the maximum lateral deformation is only about 287 mm lower than the other pillars in the same coalmine. In deep mining, the energy accumulation and release cause a discontinuous damage in the heterogeneous coal-mass, and the lateral deformation of coal pillar shows discontinuity, step and mutation characters. These coal-masses not only show a higher plasticity but also the high brittleness at the same time, and its burst tendency is more obvious. According to the monitoring results and theoretical calculations, the yield zone of the coal pillar width is determined as 15.6 m. The monitoring results presented through this study are of great significance to the stability analysis and design of coal pillar.

키워드

과제정보

연구 과제 주관 기관 : National Natural Science Foundation of China, Shandong Provincial Natural Science Fundation for Distinguished Young Scholars

참고문헌

  1. Cemalettin, O.A., Guzin, G.U. and Yilmaz, O. (2016), "Comparison of Hoek-Brown and Mohr-Coulomb failure criterion for deep open coal mine slope stability", Struct. Eng. Mech., 60(5), 809-828. https://doi.org/10.12989/sem.2016.60.5.809
  2. Chen, S.J., Guo, W.J., Zhou, H., Shen, B.T. and Liu, J.B. (2014), "Field investigation of long-term bearing capacity of strip coal pillars", J. Rock Mech. Min. Sci., 70(9), 109-114.
  3. Chen, S.J., Wang, H.L., Wang, H.Y., Guo, W.J. and Li, X.S. (2016), "Strip coal pillar design based on estimated surface subsidence in eastern china", Rock Mech. Rock Eng., 49(9), 3829-3838. https://doi.org/10.1007/s00603-016-0988-y
  4. Chen, S.J., Zhou, H., Guo, W.J., Wang, H.L. and Sun, X.Z. (2012), "Study on long-term stress and deformation characteristic of strip pillar", J. Min. Safe. Eng., 29(3), 376-380.
  5. Fahrman, B. and Westman, E. (2014), "Probabilistic approach to coal pillar design", Coal Age, 119(3), 30-33.
  6. Gao, W. and Ge, M. (2016), "Stability of a coal pillar for strip mining based on an elastic-plastic analysis", J. Rock Mech. Min. Sci., 87, 23-28.
  7. Germanovich, L.N., Dyskin, A.V. and Tsyrulnikov, N.M. (1993), "A model of the deformation and fracture of brittle materials with cracks under uniaxial compression", Mech. Solid., 28(1), 116-128.
  8. Ghasemi, E. and Shahriar, K. (2012), "A new coal pillars design method in order to enhance safety of the retreat mining in room and pillar mines", Safe. Sci., 50(3), 579-585. https://doi.org/10.1016/j.ssci.2011.11.005
  9. Guo, L.Q., Peng, X.Q. and Cai, J.P. (2013), "Design of strip coal pillar based on the unified strength theory", J. Chin. Coal Soc., 38(9), 1563-1567.
  10. Iannacchione, A.T. and Mark, C. (1992), "Evaluating coal pillar mechanics through field measurements", Proceedings of the 11th International Conference Ground Control Mining, University of Wollongong, Wollongong, Australia, July.
  11. Jayanthu, S., Singh, T.N. and Singh, D.P. (2004), "Stress distribution during extraction of pillars in a thick coal seam", Rock Mech. Rock Eng., 37(3), 171-192. https://doi.org/10.1007/s00603-003-0003-2
  12. Kukutsch, R., Kajzar, V., Waclawik, P. and Nemcik, J. (2016), "Use of 3D laser scanner technology to monitor coal pillar deformation", Proceedings of the 16th Coal Operators' Conference, Wollongong, Australia, February.
  13. Lavrikov, S.V. and Revuzhenko, A.F. (2014), "Calculation of deformation and stability of pillars in rocks", Proceedings of the International Conference on Physical Mesomechnaics of Multilevel Systems, Tomsk, Russia, September.
  14. Li, Q., Xu, H., Bu, W. and Zhao, G. (2011), "An analytic solution describing the visco-elastic deformation of coal pillars in room and pillar mine", Min. Sci. Tech., 21(6), 885-890.
  15. Mohan, G.M., Sheorey, P.R. and Kushwaha, A. (2001), "Numerical estimation of pillar strength in coal mines", J. Rock Mech. Min. Sci., 38(8), 1185-1192. https://doi.org/10.1016/S1365-1609(01)00071-5
  16. Mroz, Z. and Nawrocki, P. (1989), "Deformation and stability of an elasto-plastic softening pillar", Rock Mech. Rock Eng., 22(2), 69-108. https://doi.org/10.1007/BF01583956
  17. Myer, L.R. and Kemeny, J.M. (1992), "Extensile cracking in porous rock under different compressive stress", Appl. Mech. Rev., 45(8), 263-280. https://doi.org/10.1115/1.3119758
  18. Poulsen, B.A. (2010), "Coal pillar load calculation by pressure arch theory and near field extraction ratio" J. Rock Mech. Min. Sci., 47(7), 1158-1165. https://doi.org/10.1016/j.ijrmms.2010.06.011
  19. Recio-Gordo, D. and Jimenez, R. (2012), "A probabilistic extension to the empirical ALPS and ARMPS systems for coal pillar design", J. Rock Mech. Min. Sci., 52(3), 181-187. https://doi.org/10.1016/j.ijrmms.2012.03.009
  20. Waclawik, P., Ptacek, J., Konicek, P., Kukutsch, R. and Nemcik, J. (2016), "Stress-state monitoring of coal pillars during room and pillar extraction", J. Sustain. Min., 15(2), 49-56.
  21. Walton, G., Diederichs, M. and Punkkinen, A. (2015), "The influence of constitutive model selection on predicted stresses and yield in deep mine pillars-a case study at the creighton mine, Sudbury, Canada", Geomech. Tunn., 8(5), 441-449. https://doi.org/10.1002/geot.201500023
  22. Wu, H., Zhang, N., Wang, W., Zhao, Y. and Cao, P. (2015), "Characteristics of deformation and stress distribution of small coal pillars under leading abutment pressure", J. Min. Sci. Tech., 25(6), 921-926. https://doi.org/10.1016/j.ijmst.2015.09.007
  23. Wu, L.X. and Wang, J.Z. (1995), "Calculation of Width of yielding zone of coal pillar and analysis of influencing factors", J. Chin. Coal Soc., 20(6), 625-631.
  24. Xie, H.P., Ju, Y., Li, L.Y. and Peng, R.D. (2008), "Energy mechanism of deformation and failure of rock masses", Chin. J. Rock Mech. Eng., 27(9), 1729-1740.
  25. Yang, S.Q. (2015), "An experimental study on fracture coalescence characteristics of brittle sandstone specimens combined various flaws", Geomech. Eng., 8(4), 541-557. https://doi.org/10.12989/gae.2015.8.4.541
  26. Yu, B., Zhang, Z., Kuang, T. and Liu, J. (2016), "Stress changes and deformation monitoring of longwall coal pillars located in weak ground", Rock Mech. Rock Eng., 49(8), 1-13. https://doi.org/10.1007/s00603-015-0901-0
  27. Yu, Y.X., Huang, R. B. and Wang, B.Q. (2016), "Analysis on limit equilibrium zone of coal pillar in mining roadway based on mechanical model of elastic foundation beam", J. Eng. Mech., 142(4), 04016009. https://doi.org/10.1061/(ASCE)EM.1943-7889.0001032
  28. Zhang, X.R. (2012), "Laboratory test of coal pillar strength and deformation characteristic", Coal Min. Tech., 17(3), 17-20 (In Chinese).
  29. Zhao, T.B., Guo, W.Y., Lu, C.P. and Zhao, G.M. (2016), "Failure characteristics of combined coal-rock with different interfacial angles", Geomech. Eng., 11(3), 345-359. https://doi.org/10.12989/gae.2016.11.3.345

피인용 문헌

  1. 2D Semimodel of Full-Section Anchorage in Thick Soft Rock Roadway vol.2018, pp.None, 2018, https://doi.org/10.1155/2018/9853853
  2. Study on Failure Modes and Energy Evolution of Coal-Rock Combination under Cyclic Loading vol.2020, pp.None, 2018, https://doi.org/10.1155/2020/5731721
  3. Study on the Radial Displacement Law and Permeability Enhancement Effect of Coal Body around Hydraulic Flushing Drilling vol.2021, pp.None, 2018, https://doi.org/10.1155/2021/5535624
  4. Study on Lateral Deformation and Failure Characteristics of Coal Based on Different Confining Pressures vol.2021, pp.None, 2018, https://doi.org/10.1155/2021/6388687