DOI QR코드

DOI QR Code

Nonlinear modeling of a RC beam-column connection subjected to cyclic loading

  • Dominguez, Norberto (Seccion de Estudios de Posgrado e Investigacion (SEPI) ESIA UZ, Instituto Politecnico Nacional of Mexico) ;
  • Perez-Mota, Jesus (Seccion de Estudios de Posgrado e Investigacion (SEPI) ESIA UZ, Instituto Politecnico Nacional of Mexico)
  • Received : 2012.10.29
  • Accepted : 2018.01.04
  • Published : 2018.03.25

Abstract

When reinforced concrete structures are subjected to strong seismic forces, their beam-column connections are very susceptible to be damaged during the earthquake event. Consequently, structural designers try to fit an important quantity of steel reinforcement inside the connection, complicating its construction without a clear justification for this. The aim of this work is to evaluate -and demonstrate- numerically how the quantity and the array of the internal steel reinforcement influences on the nonlinear response of the RC beam-column connection. For this, two specimens (extracted from an experimental test of 12 RC beam-column connections reported in literature) were modeled in the Finite Element code FEAP considering different stirrup's arrays. The nonlinear response of the RC beam-column connection is evaluated taking into account the nonlinear thermodynamic behavior of each component: a damage model is used for concrete; a classical plasticity model is adopted for steel reinforcement; the steel-concrete bonding is considered perfect without degradation. At the end, the experimental responses obtained in the tests are compared to the numerical results, as well as the distribution of shear stresses and damage inside the concrete core of the beam-column connection, which are analyzed for a low and high state of confinement.

Keywords

References

  1. ACI Committee 318 (2005), Building Code Requirements for Structural Concrete (ACI 318-08) and Commentary (ACI 318R-08), American Concrete Institute, Farmington Hills, MI.
  2. Alamedinne, F. and Ehsani, M.R. (1991), "High-strength RC connections subjected to inelastic cycling loading", J. Struct. Eng., ASCE, 117(3), 829-850. https://doi.org/10.1061/(ASCE)0733-9445(1991)117:3(829)
  3. Alcocer, S. (1991), "Comportamiento y diseno de estructuras de concreto reforzado. Uniones de elementos", CENAPRED/Instituto de Ingenieria-UNAM.
  4. Brancherie, D. and Ibrahimbegovic, A. (2009), "Novel anisotropic continuum-discrete damage model capable of representing localized failure of massive structures. Part I: theoretical formulation and numerical implementation", Int. J. Eng. Comput., 26, 100-127
  5. Chakrabarty, J. (2006), Theory of Plasticity, Elsevier Butterworth-Heinemann, London, UK.
  6. Dominguez, N., Brancherie, D., Davenne, L. and Ibrahimbegovic, A. (2005), "Prediction of crack pattern distribution in reinforced concrete by coupling a strong discontinuity model of concrete cracking and a bond-slip of reinforcement model", Eng. Comput., 22(5-6), 558-582. https://doi.org/10.1108/02644400510603014
  7. Ha, G.J. and Cho, C.G. (2008), "Strengthening of reinforced highstrength concrete beam-column joints using advanced reinforcement details", Mag. Concrete Res., 60(7), 487-497. https://doi.org/10.1680/macr.2008.60.7.487
  8. Ha, G.J., Cho, C.G., Kang, H.W. and Feo, L. (2012), "Seismic improvement of RC beam-column joints using hexagonal CFRP bars combined with CFRP sheets", Compos. Struct., 95, 464-470.
  9. Ibrahimbegovic, A. (2009), Nonlinear Solid Mechanics, Springer, London/New York.
  10. Ibrahimbegovic, A. and Brancherie, D. (2003), "Combined hardening and softening constitutive model for plasticity: precursor to shear slip line failure", Comput. Mech., 31, 88-100 https://doi.org/10.1007/s00466-002-0396-x
  11. Ibrahimbegovic, A., Boulkertous, A., Davenne, L. and Brancherie, D. (2010), "Modeling of reinforced-concrete structures providing crack-spacing based on XFEM, ED-FEM and novel operator split solution procedure", Int. J. Numer. Meth. Eng., 83, 452-481.
  12. Ibrahimbegovic, A., Davenne, L., Markovic, D. and Dominguez, N. (2014), "Performance based earthquake-resistant design: Migrating towards nonlinear models and probabilistic framework", Ed. M. Fischinger, Performance Based Seismic Engineering-Vision for Earthquake Resilient Society, Springer.
  13. Ibrahimbegovic, A., Gharzeddine, F. and Chorfi, L. (1998), "Classical plasticity and viscoplasticity models reformulated: theoretical basis and numerical implementation", Int. J. Numer. Meth. Eng., 42, 499-535. https://doi.org/10.1002/(SICI)1097-0207(19980615)42:3<499::AID-NME368>3.0.CO;2-O
  14. Jehel, P., Davenne, L., Ibrahimbegovic, A. and Leger, P. (2010) "Towards robust viscoelastic-plastic-damage material model with different hardenings/softenings capable of representing salient phenomena in seismic loading applications", Comput. Concrete, 7(4), 365-386. https://doi.org/10.12989/cac.2010.7.4.365
  15. Jehel, P., Leger, P. and Ibrahimbegovic, A. (2014), "Initial versus tangent stiffness-based Rayleigh damping in inelastic time history seismic analyses", Earthq. Eng. Struct. Dyn., 43, 467-484 https://doi.org/10.1002/eqe.2357
  16. Kai, Q. and Li, B. (2012), "Dynamic performance of RC beamcolumn substructures under the scenario of the loss of a corner column-Experimental results", Eng. Struct., 42, 154-167. https://doi.org/10.1016/j.engstruct.2012.04.016
  17. Karayannis, C.G. and Sirkelis, G.M. (2008), "Strengthening and rehabilitation of RC beam-column joints using carbon-FRP jacketing and epoxy resin injection", Earthq. Eng. Struct. Dyn., 37(5), 769-790. https://doi.org/10.1002/eqe.785
  18. Kim, J. and LaFave, J.M. (2007), "Key influence parameters for the joint shear behaviour of reinforced concrete (RC) beamcolumn connections", Eng. Struct., 29(10), 2523-2539. https://doi.org/10.1016/j.engstruct.2006.12.012
  19. Kucerova, A., Brancherie, D., Ibrahimbegovic, A., Zeman, J. and Bittnar, Z. (2009), "Novel anisotropic continuum-discrete damage model capable of representing localized failure of massive structures. Part II: identification from tests under heterogeneous stress field", Int. J. Eng. Comput., 26, 128-144.
  20. Lowes, L.N. (1999), "Finite element modeling of reinforced concrete beam-column bridge connections", Ph. D. Thesis, Civil Engineering Graduated Division, University of California, Berkeley, USA.
  21. Lowes, L.N. and Moehle, J.P. (1995), "Evaluation and retrofit of beam-column T-joints in older reinforced concrete bridge structures", ACI Struct. J., 96(4), 519-532.
  22. Lowes, L.N., Mitra, N. and Altoontash, A. (2004), "A beamcolumn joint model for simulating the earthquake response of reinforced concrete frames", Pacific Earthquake Engineering Research Center, PEER Report 2003/10, University of California, Berkeley, USA.
  23. Ma, S.Y.M., Popov, E.P. and Bertero, V.V. (1976), Experimental and Analytical Studies of the Hysteretic Behavior of Reinforced Concrete Rectangular and T-Beams, Report No. EERC-76-2, EERC, University of California, Berkeley, USA.
  24. Markovic, D. and Ibrahimbegovic, A. (2004), "On micro-macro interface conditions for micro scale based FEM for inelastic behavior of heterogeneous materials", Comput. Meth. Appl. Mech. Eng., 193, 5503-5523. https://doi.org/10.1016/j.cma.2003.12.072
  25. Mazars, J. (1986), "A description of micro- and macroscale damage of concrete structures", J. Eng. Fract. Mech., 25(5-6), 729-737. https://doi.org/10.1016/0013-7944(86)90036-6
  26. Meinheit, D.F. and Jirsa, J.O. (1977), The Shear Strength of Reinforced Concrete Beam-Column Joints, CESRL Report No. 77-1, University of Texas, Austin.
  27. Park, R. and Paulay, T. (1997), Estructuras de Concreto Reforzado, Limusa, Mexico.
  28. Ragueneau, F., La Borderie, Ch. and Mazars, J. (2000), "Damage model for concrete like materials coupling cracking and friction, contribution towards structural damping: first uniaxial application", Mech. Cohes. Frict. Mater., 5, 607-625. https://doi.org/10.1002/1099-1484(200011)5:8<607::AID-CFM108>3.0.CO;2-K
  29. Sasmal, S. and Ramanjaneyulu, K. (2012), "Evaluation of strength hierarchy of beam-column joints of existing RC structures under seismic type loading", J. Earthq. Eng., 16(6), 897-915. https://doi.org/10.1080/13632469.2012.679998
  30. Sharma, A., Reddy, G.R., Eligehausen, R., Vaze, K.K., Ghosh, A.K. and Kushwaha, H.S. (2010), "Experiments on reinforced concrete beam-column joints under cyclic loads and evaluating their response by nonlinear static pushover analysis", Struct. Eng. Mech., 35(1), 99-117. https://doi.org/10.12989/sem.2010.35.1.099
  31. Taylor, R. L. (2005), "FEAP- A finite element analysis program version 7.4. User manual", http://www.ce.berkeley.edu/-rlt/feap/ .
  32. Visintin, P., Oehlers, D.J., Wu, C. and Griffith, M.C. (2012), "The reinforcement contribution to the cyclic behaviour of reinforced concrete beam hinges", Earthq. Eng. Struct. Dyn., 41(12), 1591-1608. https://doi.org/10.1002/eqe.1189
  33. Wang, Y.C. (2012), "Reinforced concrete jacketing for seismic upgrading of RC frames with poor reinforcing details in beamcolumn joints", Proceedings of the International Offshore and Polar Engineering Conference, 84-89.
  34. Wong, S.H.F. and Kuang, J.S. (2011), "Predicting shear strength of RC exterior beam-column joints by modified rotating-angle softened-truss model", Comput. Concrete, 8(1), 59-70. https://doi.org/10.12989/cac.2011.8.1.059
  35. Zhou, H. and Zhang, Z. (2012), "Interaction of internal forces of exterior beam-column joints of reinforced concrete frames under seismic action", Struct. Eng. Mech., 44(2), 197-217. https://doi.org/10.12989/sem.2012.44.2.197

Cited by

  1. Numerical Study of RC Beam-Column Joints Using a 4-Node Lattice Element Analysis Method vol.25, pp.3, 2018, https://doi.org/10.1007/s12205-021-0991-z