DOI QR코드

DOI QR Code

Effect of masonry infilled panels on the seismic performance of a R/C frames

  • Received : 2018.11.01
  • Accepted : 2019.02.01
  • Published : 2019.03.25

Abstract

The main objective of this experimental research was to investigate the Seismic performance of reinforced concrete frames infilled with perforated clay brick masonry wall of a type commonly used in Algeria. Four one story-one bay reinforced concrete infilled frames of half scale of an existing building were tested at the National Earthquake Engineering Research Center Laboratory, CGS, Algeria. The experiments were carried out under a combined constant vertical and reversed cyclic lateral loading simulating seismic action. This experimental program was performed in order to evaluate the effect and the contribution of the infill masonry wall on the lateral stiffness, strength, ductility and failure mode of the reinforced concrete frames. Numerical models were developed and calibrated using the experimental results to match the load-drift envelope curve of the considered specimens. These models were used as a bench mark to assess the effect of normalized axial load on the seismic performance of the RC frames with and without masonry panels. The main experimental and analytical results are presented in this paper.

Keywords

Acknowledgement

Supported by : CGS

References

  1. Aksel, F., Baris, B., Pourang, E., Erdem, C. and Guney, O. (2016), "The effect of infill walls on the seismic behavior of boundary columns in RC frames", Earthq. Struct., 10(3), 539-562. https://doi.org/10.12989/eas.2016.10.3.539
  2. Alessandro, V.B. and Camillo, N. (2015), "Experimental tests and global modeling of masonry infilled frames", Earthq. Struct., 9(2), 281-303. https://doi.org/10.12989/eas.2015.9.2.281
  3. Ali, M., Behnam, M. and Mohammad, R.A. (2015), "Seismic response of RC frame structures strengthened by reinforced masonry infill panels", Earthq. Struct., 8(6), 1435-1452. https://doi.org/10.12989/eas.2015.8.6.1435
  4. Bechtoula, H. (2002), "Damage assessment of reinforced concrete columns under large axial and lateral loadings", Master Degree, Kyoto, University, Japan.
  5. Brokken, S. and Bertero, V.V. (1981), "Studies on effects of infills in seismic resistant RC construction", Report UCB/EERC, 81-12, University of California, Berkeley.
  6. Calvi, G.M. and Bolognini, D. (2001), "Seismic response of reinforced concrete frames infilled with masonry panels weakly reinforced", J. Earthq. Eng., 5, 153-185. https://doi.org/10.1080/13632460109350390
  7. Crisafulli, F.J. (1997) "Seismic behavior of reinforced concrete structures with masonry infills", PhD Thesis, Department of Civil Engineering University of Canterbury Christchurch, New Zealand, July.
  8. Crisafulli, F.J. and Carr, A.J. (2007), "Proposed macro-model for the analysis of infilled frame structures", Bull. NZ Soc. Earthq. Eng., 40(2), 69-77.
  9. Egermann, R., Cook, D.A. and Anzani, A. (1991), "An investigation into the behaviour of scale model brick walls", Proceedings of the 9th International Brick/Block Masonry Conference, Berlin, Germany.
  10. Fabio, C. (2015), "Seismic behaviour of reinforced concrete frames with different configuration of masonry infill", Degree of Master Philosophy in Civil Engineering, University of Science and Technology, Hong Kong.
  11. Flanagan, R.D. and Bennett, R.M. (1999), "In-plane behaviour of structural clay tile infilled frames", J. Struct. Eng., ASCE, 125(6), 590-599. https://doi.org/10.1061/(ASCE)0733-9445(1999)125:6(590)
  12. Ghassan, A. (2002), "Evaluating Strength and Stiffness of Unreinforced Masonry Infill Structures", US Army of Corps Engineers, ERDC/CERL TR-02-1.
  13. Goutam, M. and Solomon, T. (2014), "Effects of vertical irregularity and thickness of unreinforced masonry infill on the robustness of RC framed buildings", Earthq. Eng. Struct. Dyn., 43(2), 205-223. https://doi.org/10.1002/eqe.2338
  14. Goutam, M. and Sudhir, K.J. (2008), "Lateral stiffness of masonry infilled reinforced concrete frames with central opening", Earthq. Spectra, 24(3), 701-723. https://doi.org/10.1193/1.2942376
  15. Hamid, R.K. and Kadir, M. (2016), "Experimental study of masonry infill reinforced concrete frames with and without corner openings", Struct. Eng. Mech., 57(4), 641-656. https://doi.org/10.12989/sem.2016.57.4.641
  16. Hanhui, Z., Kuang, J.S. and Terry, Y.P. (2017), "Low-seismic damage strategies for infilled RC frames: shake-table tests" Earthq. Eng. Struct. Dyn., 46(14), 2419-2438. https://doi.org/10.1002/eqe.2911
  17. Hughes, T.G. and Kitching, N. (2000), "Small scale testing of masonry", 12th International Brick/Block Masonry Conference, Madrid, Spain.
  18. Ivan, R., Damir, M. and Vladimir, S. (2016), "Controlled seismic behavior of masonry-infilled steel frames", Gradevinar, DOI: 10.14256/JCE.1673.2016, 11/2016.
  19. Jarun, S., Sutat, L., Arnon, W. and Panitan, L. (2017), "Experimental and analytical evaluation of a low-cost seismic retrofitting method for masonry-infilled non-ductile RC frames", Earthq. Struct., 12(6), 699-712. https://doi.org/10.12989/EAS.2017.12.6.699
  20. Kakaletsis, D. and Karayannis, C. (2007) "Experimental investigation of infilled r/c frames with eccentric openings", Struct. Eng. Mech., 26(3), 231-250. https://doi.org/10.12989/sem.2007.26.3.231
  21. Lotfi, H.R. and Shing, P.B. (1994), "An interface model applied to fracture of masonry structures", J. Struct. Eng., ASCE, 120(1), 63-80. https://doi.org/10.1061/(ASCE)0733-9445(1994)120:1(63)
  22. Maidiawati (2013), "Modeling of brick masonry infill for seismic performance evaluation of RC frame buildings", Doctor of Engineering, Toyohashi University of Technology.
  23. Masanori, H. and Kheir-Eddine, R. (2004), "Boumerdes Earthquake the 21st May 2003", Japanese Reconnaissance Team, technical Report, DOI: 10.13140/RG.2.2.36186.34249.
  24. Menegotto, M. and Pinto, P.E. (1973), "Method of analysis of cyclically loaded RC plane frames including changes in geometry and non-elastic behavior of elements under normal force and bending", Proceedings of IABSE Symposium on Resistance and Ultimate Deformability of Structures Acted on by Well Defined Repeated Loads, 15-22.
  25. Ministere de l'Habitat et de l'Urbanisme, M.H.U.V. et Centre National de Recherche Appliquee en Genie Parasismique, C.G.S. (2003), Reglement Parasismique Algerien, RPA 99 version 2003, Algeria.
  26. Ministere de l'Habitat et de l'Urbanisme, M.H.U.V. et Centre National d'Etudes et de Recherches Integrees du Batiment, CNERIB (2005), "Regles de conception et de calcul des maconneries DTR C2-45", Algeria.
  27. Misir, I.S., Ozcelik, O., Sadik, C.G. and Serap, K. (2012), "Experimental work on seismic behavior of various types of masonry infilled RC frames", Struct. Eng. Mech., 44(6), 763-774. https://doi.org/10.12989/sem.2012.44.6.763
  28. Ousalem, H. and Bechtoula, H. (2003), "Report on the damage investigation and post-seismic campaign of the 2003 Zemmouri Earthquake in Algeria", The University of Tokyo Department of Architecture 2003 by Earthquake Research Institute, The University of Tokyo C/O Kabeyasawa Laboratory, Division of Disaster Mitigation Science, Tokyo, Japan.
  29. Ozakaynak, H., Yuksel, E., Yakin, C., Dindar, A.A. and Buyukozturk, O. (2015), "Masonry infill walls in reinforced concrete frames as a source of structural damping", Earthq. Eng. Struct. Dyn., 43(7), 949-968. https://doi.org/10.1002/eqe.2380
  30. Pinto, A.V., Varum, H. and Molina, J. (2000), "Experimental assessment and retrofit of full-scale models of existing RC frames", Proc. 12th ECEE, London.
  31. Preti, M., Bettini, N. and Plizzari, G. (2012), "Infill walls with sliding joints to limit infill-Frame seismic interaction: largescale experimental test", J. Earthq. Eng., 16(1), 125-141. https://doi.org/10.1080/13632469.2011.579815
  32. Sayed, M.M.E. and Majid, M. (2016), "Influence of vertical load on in-plane behavior of masonry infilled steel frames", Earthq. Struct., 11(4), 609-627. https://doi.org/10.12989/eas.2016.11.4.609
  33. SeismoSoft (2016), SeismoStruct-A Computer Program for the Static and Dynamic Analysis of Framed Structures, http://www.seismosoft.com.
  34. Shabdin, M., Attari, N.K. and Zargaran, M. (2018), "Experimental study on seismic behavior of Un-Reinforced masonry (URM) brick walls strengthened with shotcrete", Bull. Earthq. Eng., 16(9), 3931-3956. https://doi.org/10.1007/s10518-018-0340-x
  35. Shabita, A. and Sozen, M.A. (1976), "Substitute structure method for seismic design in RC", J. Struct. Div., ASCE, 102(ST1), 1-18. https://doi.org/10.1061/JSDEAG.0004250
  36. Shahriar, Q., Shahria, M.A. and Rteil, A. (2013) "Seismic behavior of soft storey mid-rise steel frames with randomly distributed masonry infill", Steel Compos. Struct., 14(6), 523-545. https://doi.org/10.12989/scs.2013.14.6.523
  37. Smyrou, L. (2006), "Implementation and verification of masonry panel model for nonlinear dynamic analysis of infilled RC frame", PhD in European School for Advanced Studies in Reduction of Seismic Risk, Rose school, Pavia, Italy.
  38. Stylianidis, K.C. (2012), "Experimental investigation of masonry infilled R/C frames", Open Constr. Build. Technol. J., 6, 194-212. https://doi.org/10.2174/1874836801206010194
  39. Teguh, M. (2017), "Experimental evaluation of masonry infill walls of RC frame building subjected to cyclic loads", Procedia Engineering, SCESCM, Sustainable Civil Engineering Structures and Construction Materials.
  40. Terry, Y.P.Y., Han-hui, Z., Kuang, J.S. and Qunxian, H. (2018), "Shake table tests on RC frame infilled by slitted masonry panels", Bull. Earthq. Eng., 16(9), 4027-4052. https://doi.org/10.1007/s10518-018-0339-3
  41. Tsung-Chih, C. and Shyh-Jian, H. (2015), "Tests on cyclic behavior of reinforced concrete frames with brick infill" Earthq. Eng. Struct. Dyn., 44(12), 1939-1958. https://doi.org/10.1002/eqe.2564
  42. Yasushi, S., Yoshiaki, N., Kazuto, M., Devjyoti, P., Polat, G. and Baris, B. (2017), "Experimental evaluation of the in-plane behaviour of masonry wall infilled RC frames", Bull. Earthq. Eng., 15(10), 4245-4267. https://doi.org/10.1007/s10518-017-0139-1