한국분무공학회지 (Journal of ILASS-Korea)

  • 제25권1호
  • /
  • Pages.21-26
  • /
  • 2020
  • /
  • 1226-2277(pISSN)
  • /
  • 2288-9051(eISSN)
한국분무공학회 (Institute for Liquid Atomization and Spray Systems-Korea)
권호 표지
DOI QR코드

DOI QR Code

CO2를 포함한 Simulated-EGR 압축착화엔진에서 당량비 변화에 따른 성능 예측

Performance Prediction according to Equivalence Ratio Change in Simulated-EGR Compression Ignition Engine Containing CO2

  • 서현규 (공주대학교 기계자동차공학부)
  • 투고 : 2020.02.23
  • 심사 : 2020.03.04
  • 발행 : 2020.03.30
PDF 다운로드
⟨ 이전 논문 다음 논문 ⟩

초록

The objective of this work is to numerically reveal the effect of equivalence ratio change on the simultaneous reduction of NOX and soot emissions from the simulated-EGR compression ignition engine containing CO2. An experiment was conducted by using a single-cylinder common-rail injection system engine, an intake control system, and exhaust emissions analyzers. The numerical analysis results were validated under the same experimental conditions. To investigate the effect of equivalence ratio by simulated-EGR containing CO2, the O2, N2, and CO2 mole fraction were changed in the initial air conditions to the cylinder. The results were analyzed in terms of peak cylinder pressure, indicated mean effective pressure, indicated specific nitrogen oxide, and indicated specific soot. It was revealed that ignition delay characteristics and heat release rate (ROHR) characteristics were not significantly different according to the equivalence ratio. However, as the equivalence ratio increased from 0.68 to 0.83, the maximum combustion pressure and IMEP decreased by about 6.5% and 9.4%, respectively. In the case of ISFC, as is well known, the trend is opposite of IMEP. In the case of ISNO, as the equivalence ratio increased, less NO was generated, and as the equivalence ratio increased by 0.05, the ISSoot value of about 10% increased.

키워드

참고문헌

  1. S. Turns, "An introduction to combustion: Concepts and applications", McGraw-Hill Education (Asia), Third Edition, 2012.
  2. Y. S. Park and C. S. Bae, "Experimental study on the effects of high/low pressure EGR proportion in a passenger car diesel engine", Journal of Applied Energy, Vol. 133, 2014, pp. 308-316. https://doi.org/10.1016/j.apenergy.2014.08.003
  3. D. T. Hountalas, G. C. Mavropoulos and K. B. Binder, "Effect of exhaust gas recirculation (EGR) temperature for various EGR rates on heavy duty DI diesel engine performance and emissions", Journal of Energy, Vol. 33, 2008, pp. 272-283. https://doi.org/10.1016/j.energy.2007.07.002
  4. G. K. Kokkulunk, A. Parlak, V. Z. Ayhan and I. Cesur, "Investigation of steam injection with exhaust gas recirculation (EGR) on a diesel engine", Journal of Latest Trends in Sustainable and Green Development Conference, 2012, pp. 41-46.
  5. S. H. Kook, J. S. Kong, S. I. Park, C. S. Bae and J. H. Kim, "The effect of injection angle and nozzle diameter on HCCI combustion", Transactions of KSAE, Vol. 15, No. 2, 2007, pp. 1-7.
  6. J. E. II Parks, V. Prikhodko, J. M. E. Storey, T. L. Barone, S. A. Sr. Lewis, M. D. Kass and S. P. Huff, "Emissions from premixed charge compression ignition (PCCI) combustion and affect on emission control devices", Journal of Catalysis Today, Vol. 151, 2010, pp. 278-284. https://doi.org/10.1016/j.cattod.2010.02.053
  7. B. Rohani, S. S. Park and C. S. Bae, "Effect of injection strategy on smoothness, emissions and soot characteristics of PCCI-conventional diesel mode transition", Journal of Applied Thermal Engineering, Vol. 93, 2016, pp. 1033-1042. https://doi.org/10.1016/j.applthermaleng.2015.09.075
  8. Z. Peng, H. Zhao and T. Ma, "Characteristics of premixed homogeneous charge compression ignition (HCCI) diesel combustion and emissions", Journal of Combustion Science and Technology, Vol. 177, No. 11, 2005, pp. 2113-2150. https://doi.org/10.1080/00102200500240588
  9. M. Y. Kim and C. S. Lee, "Effect of a narrow fuel spray angle and a dual injection configuration on the improvement of exhaust emissions in a HCCI diesel engine", Journal of Fuel, Vol. 86, 2007, pp. 2871-2880. https://doi.org/10.1016/j.fuel.2007.03.016
  10. J. P. Cha, S. J. Yoon, S. H. Lee and S. W. Park, "Effects of intake oxygen mole fraction on the near-stoichiometric combustion and emission characteristics of a CI (compression ignition) engine", Journal of Energy, Vol. 80, No. 1, 2015, pp. 677-686. https://doi.org/10.1016/j.energy.2014.12.023
  11. S. H. Min, H. K. Suh and J. P. Chan, "Effect of Simulated-EGR ($N_2$) on the distribution characteristics of equivalence ratio and the formation of exhaust emissions in a CI engine under early injection conditions", Journal of Energy, Vol. 193, 116850, 2020, pp. 1-12.
  12. AVL GmbH, Fire Version 2013 Combustion Module Manual, 2013.
  13. AVL GmbH, Fire Version 2013.2 Spray Module Manual, 2013.
  14. AVL List GmbH, Fire Version 2013 ESE-Diesel (Engine Simulation Environment) Module Manual, 2013.
  15. W. Bosch, "The fuel rate indicator : A new measuring instrument for display of the characteristics of individual injection", SAE 660749, 1966.