Acknowledgement
This work was supported by the National Research Foundation of Korea (NRF) grant funded by the Korea Government (MSIT) (No. 2019R1A2C1007815) and this research was supported by a grant (21SCIP-B146646-04) from Construction Technology Research Project funded by the Ministry of Land, Infrastructure and Transport of Korea government.
References
- ACI Committee 318 (2008), Building Code Requirements for Structural Concrete and Commentary, 28, 0-15.
- Al-Zaid, R.Z., Al-Negheimish, A.I., Al-Saawani, M.A. and El-Sayed, A.K. (2012), "Analytical study on RC beams strengthened for flexure with externally bonded FRP reinforcement", Compos. Part B: Eng., 43(2), 129-141. https://doi.org/10.1016/j.compositesb.2011.11.015.
- Astarlioglu, S. and Krauthammer, T. (2014), "Response of normal-strength and ultra-high-performance fiber-reinforced concrete columns to idealized blast loads", Eng. Struct., 61, 1-12. https://doi.org/10.1016/j.engstruct.2014.01.015.
- Astarlioglu, S., Krauthammer, T., Morency, D. and Tran, T.P. (2013), "Behavior of reinforced concrete columns under combined effects of axial and blast-induced transverse loads", Eng. Struct., 55, 26-34. https://doi.org/10.1016/j.engstruct.2012.12.040.
- Biggs, J.M. (1964), Introduction to Structural Dynamics, Vol. 3, McGraw-Hill, New York.
- Burrell, R.P., Aoude, H. and Saatcioglu, M. (2014), "Response of SFRC columns under blast loads", J. Struct. Eng., 141(9), 1-15. https://doi.org/10.1061/(ASCE)ST.1943-541X.0001186.
- Cadoni, E., Solomos, G. and Albertini, C. (2009), "Mechanical characterisation of concrete in tension and compression at high strain rate using a modified Hopkinson bar", Mag. Concrete Res., 61(3), 221-230. https://doi.org/10.1680/macr.2006.00035.
- Carta, G. and Stochino, F. (2013), "Theoretical models to predict the flexural failure of reinforced concrete beams under blast loads", Eng. Struct., 49, 306-315. https://doi.org/10.1016/j.engstruct.2012.11.008.
- Chopra, A.K. (1995), Dynamics of Structures, Vol. 3, Prentice Hall, New Jersey.
- Cusatis, G. (2011), "Strain-rate effects on concrete behavior", Int. J. Impact Eng., 38(4), 162-170. https://doi.org/10.1016/j.ijimpeng.2010.10.030.
- Dragos, J. and Wu, C. (2014), "Interaction between direct shear and flexural responses for blast loaded one-way reinforced concrete slabs using a finite element model", Eng. Struct., 72, 193-202. https://doi.org/10.1016/j.engstruct.2014.04.043.
- Fujikake, K., Li, B. and Soeun, S. (2009), "Impact response of reinforced concrete beam and its analytical evaluation", J. Struct. Eng., 135(8), 938-950. https://doi.org/10.1061/(asce)st.1943-541x.0000039
- Gang, H.G. and Kwak, H.G. (2017), "A strain rate dependent orthotropic concrete material model", Int. J. Impact Eng., 103, 211-224. https://doi.org/10.1016/j.ijimpeng.2017.01.027.
- Gergely, P. and Lutz, L.A. (1968), "Maximum crack width in reinforced concrete flexural members", ACI Spec. Publ., 20, 87-117.
- Haido, J.H., Bakar, B.H.A., Abdul-razzak, A.A. and Jayaprakash, J. (2010), "Dynamic response simulation for reinforced concrete slabs", Simul. Model. Pract. Theory, 18(6), 696-711. https://doi.org/10.1016/j.simpat.2010.01.011.
- Hawkins, N.M. (1974), "The strength of stud shear connections", Civil Eng. Tran., 39-45.
- Jacques, E. (2011), "Blast retrofit of reinforced concrete walls and slabs", Master Thesis, University of Ottawa, Canada.
- Jacques, E., Lloyd, A., Imbeau, P., Palermo, D. and Quek, J. (2015), "GFRP-retrofitted reinforced concrete columns subjected to simulated blast loading", J. Struct. Eng., 141(11), 1-13. https://doi.org/10.1061/(ASCE)ST.1943-541X.0001251.
- Jones, J., Wu, C., Oehlers, D.J., Whittaker, A.S., Sun, W., Marks, S. and Coppola, R. (2009), "Finite difference analysis of simply supported RC slabs for blast loadings", Eng. Struct., 31(12), 2825-2832. https://doi.org/10.1016/j.engstruct.2009.07.011.
- Krauthammer, T. and Astarlioglu, S. (2017), "Direct shear resistance models for simulating buried RC roof slabs under airblast-induced ground shock", Eng. Struct., 140, 308-316. https://doi.org/10.1016/j.engstruct.2017.02.056.
- Krauthammer, T., Bazeos, N. and Holmquist, T.J. (1986), "Modified SDOF analysis of RC box-type structures", J. Struct. Eng., ASCE, 112(4), 726-744. https://doi.org/10.1061/(ASCE)0733-9445(1986)112:4(726).
- Krauthammer, T., Shanaa, H.M. and Assadi, A. (1990), "Response of reinforced concrete elements to severe impulsive loads", J. Struct. Eng., ASCE, 116(4), 1061-1079. https://doi.org/10.1061/(ASCE)0733-9445(1990)116:4(1061).
- Kwak, H.G. and Filippou, F.C. (1990), "Finite element analysis of reinforced concrete structures under monotonic loads. In Structural Engineering, Mechanics and Materials", Department of Civil Engineering, University of California Berkeley, CA.
- Kwak, H.G. and Gang, H.G. (2015), "An improved criterion to minimize FE mesh-dependency in concrete structures under high strain rate conditions", Int. J. Impact Eng., 86, 84-95. https://doi.org/10.1016/j.ijimpeng.2015.07.008.
- Kwak, H.G. and Hwang, J.W. (2010), "FE model to simulate bond-slip behavior in composite concrete eam bridges", Comput. Struct., 88(17-18), 973-984. https://doi.org/10.1016/j.compstruc.2010.05.005.
- Kwak, H.G. and Kim, J.K. (2006), "Implementation of bond-slip effect in analyses of RC frames under cyclic loads using layered section method", Eng. Struct., 28(12), 1715-1727. https://doi.org/10.1016/j.engstruct.2006.03.003.
- Kwak, H.G. and Kim, S.P. (2001), "Nonlinear analysis of RC beam subject to cyclic loading", J. Struct. Eng., 127(12), 1436-1444. https://doi.org/10.1061/(asce)0733-9445(2001)127:12(1436)
- Kwak, H.G. and Kim, S.P. (2002), "Nonlinear analysis of RC beams based on moment-curvature relation", Comput. Struct., 80, 615-628. https://doi.org/10.1016/S0045-7949(02)00030-5
- Kwak, H.G., Kim, S.P. and Kim, J.E. (2004), "Nonlinear dynamic analysis of RC frames using cyclic moment-curvature relation", Struct. Eng. Mech., 17(3_4), 357-378. https://doi.org/10.12989/sem.2004.17.3_4.357.
- Lakshmi, B. and Shanmugam, N.E. (2002), "Nonlinear analysis of in-filled steel-concrete composite columns", J. Struct. Eng., 128(7), 922-933. https://doi.org/10.1061/(ASCE)0733-9445(2002)128:7(922).
- Li, J. and Hao, H. (2013), "Influence of brittle shear damage on accuracy of the two-step method in prediction of structural response to blast loads", Int. J. Impact Eng., 54, 217-231. https://doi.org/10.1016/j.ijimpeng.2012.11.008.
- Lloyd, A.E.W. (2015). "Blast retrofit of reinforced concrete columns", Ph.D. Dissertation, University of Ottawa.
- Low, H.Y. and Hao, H. (2002), "Reliability analysis of direct shear and flexural failure modes of RC slabs under explosive loading", Eng. Struct., 24(2), 189-198. https://doi.org/10.1016/S0141-0296(01)00087-6.
- Magnusson, J. and Hallgren, M. (2000), "High performance concrete beams subjected to shock waves from air blast", Swedish Defence Research Agency.
- Menegotto, M. and Pinto, P.E. (1973), "Method of analysis for cyclically loaded R.C. Plane frames including changes in geometry and non-elastic behavior of elements under combined normal force and bending", Proceedings of IABSE Symposium on Resistance and Ultimate Deformability of Structures Acted on by Well Defined Loads, 15-22. https://doi.org/http://dx.doi.org/10.5169/seals-13741.
- O.Hallquist, J. (2007), LS-DYNA Keyword User's Manual.
- Park, G.K., Kwak, H.G. and Filippou, F.C. (2017), "Blast analysis of RC beams based on moment-curvature relationship considering fixed-end rotation", J. Struct. Eng., 143(9), 04017104. https://doi.org/10.1061/(ASCE)ST.1943-541X.0001837.
- Park, G.K., Kwak, H.G. and Filippou, F.C. (2018), "Evaluation of nonlinear behavior and resisting capacity of reinforced concrete columns subjected to blast loads", Eng. Fail. Anal., 93, 268-288. https://doi.org/10.1016/j.engfailanal.2018.07.024.
- Park, R. and Paulay, T. (1975), Reinforced Concrete Structures, A Wiley-Interscience Publication.
- Qu, Y., Li, X., Kong, X., Zhang, W. and Wang, X. (2016), "Numerical simulation on dynamic behavior of reinforced concrete beam with initial cracks subjected to air blast loading", Eng. Struct., 128, 96-110. https://doi.org/10.1016/j.engstruct.2016.09.032.
- Saatcioglu, M., Lloyd, A., Jacques, E., Braimah, A. and Doudak, G. (2011), "Focused research for development of a CSA standard on design and assessment of buildings subjected to blast loads", Interim Report Submitted to Public Works and Government Services Canada, Hazard Mitigation and Disaster Management Research Centre, University of Ottawa, Ottawa, Canada.
- Sawyer, H.A. (1964), "Design of concrete frames for two failure stages", ACI Spec. Publ., 12, 405-437.
- Scott, B.D., Park, R. and Priestley, M.J.N. (1982), "Stress-strain behavior of concrete confined by overlapping hoops at low and high strain rates", ACI J. Proc., 79(1), 13-27.
- Shi, Y., Hao, H. and Li, Z.X. (2008), "Numerical derivation of pressure-impulse diagrams for prediction of RC column damage to blast loads", Int. J. Impact Eng., 35(11), 1213-1227. https://doi.org/10.1016/j.ijimpeng.2007.09.001
- Silva, P.F. and Lu, B. (2009), "Blast resistance capacity of reinforced concrete slabs", J. Struct. Eng., 135(6), 708-716. https://doi.org/10.1061/(asce)st.1943-541x.0000011
- Solomos, G. and Berra, M. (2010), "Rebar pullout testing under dynamic Hopkinson bar induced impulsive loading", Mater. Struct./Materiaux et Constructions, 43(1-2), 247-260. https://doi.org/10.1617/s11527-009-9485-z.
- Taucer, F.F., Spacone, E. and Filippou, F.C. (1991), "A fiber beamcolumn element for seismic response analysis of reinforced concrete structures", Earthquake Engineering Research Center.
- Wu, Y., Crawford, J.E. and Magallanes, J.M. (2012), "Performance of LS-DYNA concrete constitutive models", 12th International LS-DYNA Users Conference, 1, 1-14.
- Xu, J., Wu, C. and Li, Z.X. (2014), "Analysis of direct shear failure mode for RC slabs under external explosive loading", Int. J. Impact Eng., 69, 136-148. https://doi.org/10.1016/j.ijimpeng.2014.02.018.