• Journal of The Korean Society of Agricultural Engineers
• /
• v.48 no.5
• /
• pp.51-60
• /
• 2006

In order to examine the heat transfer characteristic of a soil warming system and effects of soil warming on the greenhouse heating load, control experiments were performed in two greenhouses covered with double polyethylene film. One treated the soil warming with an electric heat wire and the other treated a control. Inside and outside air temperature, soil temperature and heat flux, and heating energy consumption were measured under the set point of heating temperature of $5,\;10,\;15,\;and\;20^{\circ}C$, respectively. Soil temperatures in a soil warming treatment were observed $4.1\;to\;4.9^{\circ}C$ higher than a control. Heating energy consumptions decreased by 14.6 to 30.8% in a soil warming treatment. As the set point of heating temperature became lower, the rate of decrease in the heating energy consumptions increased. The percentage of soil heat flux in total heating load was -49.4 to 24.4% and as the set point of heating temperature became higher, the percentage increased. When the set point of heating temperature was low in a soil warming treatment, the soil heat flux load was minus value and it had an effect on reducing the heating load. Soil heat flux loads showed in proportion to the air temperature difference between the inside and outside of greenhouse but they showed big difference according to the soil warming treatment. So new model for estimation of the soil heat flux load should be introduced. Convective heat transfer coefficients were in proportion to the 1/3 power of temperature difference between the soil surface and the inside air. They were $3.41\;to\;12.42\;W/m^{2}^{\circ}C$ in their temperature difference of $0\;to\;10^{\circ}C$. Radiative heat loss from soil surface in greenhouse was about 66 to 130% of total heating load. To cut the radiation loss by the use of thermal curtains must be able to contribute for the energy saving in greenhouse.

• Geomechanics and Engineering
• /
• v.15 no.4
• /
• pp.965-972
• /
• 2018

In deep braced excavations, struts and walers play an essential role in the whole supporting system. For multi-level strut systems, accidental strut failure is possible. Once a single strut fails, it is possible for the loads carried from the previous failed strut to be transferred to the adjacent struts and therefore cause one or more struts to fail. Consequently, progressive collapse may occur and cause the whole excavation system to fail. One of the reasons for the Nicoll Highway Collapse was attributed to the failure of the struts and walers. Consequently, for the design of braced excavation systems in Singapore, one of the requirements by the building authorities is to perform one-strut failure analyses, in order to ensure that there is no progressive collapse when one strut was damaged due to a construction accident. Therefore, plane strain 2D and three-dimensional (3D) finite element analyses of one-strut failure of the braced excavation system were carried out in this study to investigate the effects of one-strut failure on the adjacent struts.

• Physical Therapy Korea
• /
• v.2 no.2
• /
• pp.9-23
• /
• 1995

The objective of this study was to identify the effects of weight-transfer training on the weight bearing distribution and gait patterns of hemiplegic patients through visual and auditory feedback using a limb load monitor. The subjects of this study were 18 hemiplegic patients who had been hospitalized or were visited out-patient department of the Rehabilitation Hospital, College of Medicine, Yonsei University, from January 5, 1995 through March 15, 1995. Pre-and post-training changes in gait patterns were measured using ink foot prints as well as by recording weight bearing distribution using a limb load monitor. The data were analyzed by the repeated measure one-way ANOVA and paired t-test. The finding were as follows: 1. Prior to the training, 18 subjects bore more weight on the sound leg(61.6 %) than on the affected leg(38.4 %). 2. Posterior to the training, the average percentage of weight bearing on the affected leg increased significantly from 38.4 % prior to training; to 46.0 % immediately after training; 45.7 % after a 30 second delay; and 45.3 % after a 60 second 3. The difference in gait patterns between pre- and post- training was statistically significant, with an increase in gait velocity to 3.65 cm/sec post-training; an increase in stride length to 5.37 cm on the affected side; 4.77 cm on the sound side; and a narrowing of the base of support to 1.19 cm. In conclusion, hemiplegic weight-transfer training using visual and auditory feedback with a limb load monitor was found to be enhancing symmetrical standing posture, and simultaneously improve gait patterns.

• Journal of Embryo Transfer
• /
• v.29 no.2
• /
• pp.171-175
• /
• 2014

This study was conducted to determine the efficacy of anthelmintics against gastrointestinal parasitic infestation in periparturient dairy cows and its effect on milk yield and quality. Sixty pregnant cows of 1st & 2nd parity were divided into four groups. The efficacy of anthelmintic treatment was evaluated by counting faecal egg per gram (EPG) compared with pre-treatment values. The milk yield of each cow was recorded in pre and post treatment lactations. Cows of group A were treated with Nitroxynil 10 mg/kg body weight subcutaneously 30 days before parturition, group B were treated with combination of triclabendazole and levamisole 19.5 mg/kg body weight orally at calving and group C treated with $Endex^{(R)}$ at calving and 42 days after. The mean change in EPG 14 days after treatment was significantly higher (p<0.05) in treated (79.1%) cows than control. Average milk yield of group C ($2.8{\pm}0.8$) was significantly higher (p<0.01) than group A ($2.6{\pm}0.7$). Similarly, the average milk yield in all the treated cows was significantly (p<0.01) higher in treated lactation ($2.5{\pm}0.7$) than in the previous lactation ($2.2{\pm}0.7$). The average milk yield in all treated cows was significantly (p<0.01) higher than the control cows. Although, milk yields were higher in second parity than the first, there was no significant difference (p>0.05). The milk protein percentage was significantly higher (p<0.05) in treated group than the control group. Therefore, it may be concluded that periparturient anthelmintic treatment effectively reduced the gastrointestinal parasitic load and improved milk yield.

• Proceedings of the KOSOMBE Conference
• /
• v.1997 no.05
• /
• pp.374-378
• /
• 1997

Operative procedures such as core drilling with and without fibular bone grafting have been recognized as the treatment methods for osteonecrosis of femoral head(ONFH) by delaying or preventing the collapse of the femoral head. In addition, core drilling with cementation using polymethylmethacrylate (PMMA) has been proposed recently as another surgical method. However, no definite treatment modality has been found yet while operative procedures remain controversial to many clinicians In this study, a finite element method(FEM) was employed to analyze and compare various surgical procedures of ONFH to provide a biomechanical insight. This study was based upon biomechanical findings which suggest stress concentration within the femoral head may facilitate the progression of the necrosis and eventual collapse. For this purpose, five anatomically relevant hip models were constructed in three dimensions : they were (1) intact(Type I), (2) necrotic(Type II), (3) core drilled only(Type III), (4) core drilled with fibular bone graft(Type IV), and (5) core drilled with cementation(Type V). Physiologically relevant loading were simulated. Resulting stresses were calculated. Our results showed that the volumetric percentage subjected to high stress in the necrotic cancellous region was greatest in the core drilled only model(Type III), followed by the necrotic(Type II), the bone graft (Type IV), and the cemented(Type V) models. Von Mises stresses at the tip of the graft(Type IV) was found to be twice more than those of cemented core(Type V) indicating the likelihood of the implant failure. In addition, stresses within the cemented core(Type V) were more evenly distributed and relatively lower than within the fibular bone graft(Type IV). In conclusion, our biomechanical analyses have demonstrated that the bone graft method(Type IV) and the cementation method(Type V) are both superior to the core decompression method(Type III) by reducing the high stress regions within the necrotic cancellous bone. Also it was found that the core region filled with PMMA(Type V) provides far smoother transfer of physiological load without causing the concentration of malignant stresses which may lead to the failure than with the fibular bone graft(Type IV). Therefore, considering the above results along with the degree of difficulties and risk of infection involved with preparation of the fibular bone graft, the cementation method appears to be a promising surgical treatment for the early stage of osteonecrosis of the femoral head.