한국초전도ㆍ저온공학회논문지 (Progress in Superconductivity and Cryogenics)

  • 제18권2호
  • /
  • Pages.1-4
  • /
  • 2016
  • /
  • 1229-3008(pISSN)
  • /
  • 2287-6251(eISSN)
한국초전도저온학회 (The Korean Society of Superconductivity and Cryogenics)
권호 표지
DOI QR코드

DOI QR Code

Local transport properties of coated conductors by laser-scan imaging methods

  • 투고 : 2016.06.02
  • 심사 : 2016.06.24
  • 발행 : 2016.06.30
PDF 다운로드
⟨ 이전 논문 다음 논문 ⟩

초록

To observe the superconducting current and structural properties of high critical temperature ($T_c$) superconductors (HTS), we suggest the following imaging methods: Room temperature imaging (RTI) through thermal heating, low-temperature bolometric microscopy (LTBM) and Raman scattering imaging. RTI and LTBM images visualize thermal-electric voltages as different thermal gradients at room temperature (RT) and superconducting current dissipation at near-$T_c$, respectively. Using RTI, we can obtain structural information about the surface uniformity and positions of impurities. LTBM images show the flux flow in two dimensions as a function of the local critical currents. Raman imaging is transformed from Raman survey spectra in particular areas, and the Raman vibration modes can be combined. Raman imaging can quantify the vibration modes of the areas. Therefore, we demonstrate the spatial transport properties of superconducting materials by combining the results. In addition, this enables visualization of the effect of current flow on the distribution of impurities in a uniform superconducting crystalline material. These imaging methods facilitate direct examination of the local properties of superconducting materials and wires.

키워드

참고문헌

  1. Y. Shiohara, M. Yoshizumi, T. Izumi and Y. Yamada, "Present status and future prospect of coated conductor development and its application in Japan," Supercond. Sci. Technol., vol. 21, pp. 1-7, 2008.
  2. M. Chen, L. Donzel, M. Lakner and W. Paul, "High temperature superconductors for power applications," J. Eur. Ceram. Soc., vol. 24, pp. 1815, 2004. https://doi.org/10.1016/S0955-2219(03)00443-6
  3. K. Salama, S. P. Athur and U. Balachandran, "Texturing of REBCO using temperature gradient," Physica C, vol. 357-360, pp. 11-19 2001. https://doi.org/10.1016/S0921-4534(01)00183-6
  4. T. Aytug, M. Paranthaman, L. Heatherly, Y. Zuev, Y. Zhang, K. Kim, A. Goyal, V. A. Maroni, Y. Chen and V. Selvamanickam, "Deposition studies and coordinated characterization of MOCVD YBCO films on IBAD-MgO templates," Supercond. Sci. Technol., vol. 22, pp. 015008, 2006.
  5. E. Goodilin, M. Limonov, A. Panfilov, N. Khasanova, A. Oka, S. Tajima and Y. Shiohara, "Oxygen nonstoichiometry and phase transitions of the neodymium-rich $Nd_{1+x}Ba_{2-x}Cu_3O_z$ solid solution," Physica C, vol. 300, pp. 250, 1998. https://doi.org/10.1016/S0921-4534(98)00114-2
  6. C. Hohn, M. Galffy, A. Dascoulidou, A. Freimuth, H. Soltner and U. Poppe, "Seebeck-effect in the mixed state of Y-Ba-Cu-O," Z. Phys. B-Condensed Matter, vol. 85, pp. 161-168, 1991. https://doi.org/10.1007/BF01313216
  7. J. A. Walraven, Edward I. Cole Jr. and P. Tangyunyong, "Failure Analysis of MEMS Using Thermally-Induced Voltage Alteration," International Symposium for Testing and Failure Analysis, 2000.
  8. D. A. Redfern, J. A. Thomas, C. A. Musca, J. M. Dell and L. Faraone, "Diffusion length measurements in p-HgCdTe using laser beam induced current," J. Electron. Mater., vol. 30, pp. 696, 2001. https://doi.org/10.1007/BF02665858
  9. S. A. Galloway, P. R. Edwards and K. Durose, "Characterization of thin-film CdS/CdTe solar cells using electron beam induced current," Solar Energy Materials & Solar Cells, vol. 57, pp. 61-74, 1999. https://doi.org/10.1016/S0927-0248(98)00168-8
  10. E. I. Cole Jr., P. Tangyunyong, D. A. Benson and D. L. Barton, "TIVA and SEI development for Enhanced Frond and Backside Interconnection Failure Analysis," Microelectronics Reliability, vol. 39, pp. 991-996, 1999. https://doi.org/10.1016/S0026-2714(99)00136-5
  11. G. Kim, W. Jo, A. Matsekh, M. Inoue, T. Kiss, H.-S. Ha and S. S. Oh, "Current Limiting Phenomena in $SmBa_2Cu_3O_7$ Coated Conductors Observed by Laser-Induced Thermoelectric Imaging and Low-Temperature Laser Scanning Microscopy," IEEE Trans. Appl. Supercon., vol. 21, pp. 3421, 2011. https://doi.org/10.1109/TASC.2010.2086040
  12. J. L. MacManus-Driscoll, M. Bianchetti, A. Kursumovic, G. Kim, W. Jo, H. Wang, J. H. Lee, G. W. Hong and S. H. Moon, "Strong pinning in very fast grown reactive co-evaporated $GdBa_2Cu_3O_7$ coated conductors," APL Materials, vol. 2, pp. 086103, 2014. https://doi.org/10.1063/1.4893339
  13. G. Kim, H. J. Jin, W. Jo, D. H. Nam, H. Cheong, H.S. Kim, S.S. Oh, R.K. Ko, Y.S. Jo and D.W. Ha, "Ultra-large current transport in thick $SmBa_2Cu_3O_{7-x}$ films grown by reactive co-evaporation," Physica C, vol. 513, pp. 29-34, 2015. https://doi.org/10.1016/j.physc.2015.03.019
  14. H. S. Kim, S.-S. Oh, H.-S. Ha, D. Youm, S.H. Moon, J. H. Kim, S. X. Dou, Y.U. Heo, S. H. Wee and A. Goyal, "Ultra-High Performance, High-Temperature Superconducting Wires via Cost-effective, Scalable, Co-evaporation Process," Sci. Rep., vol. 4, pp. 4744, 2014.
  15. K. Venkataraman, R. Baurceanu and V. A. Maroni, "Characterization of $MBa_2Cu_3O_{7-x}$ Thin Films by Raman Microspectroscopy," Applied Spectroscopy, vol. 59, pp. 639, 2005. https://doi.org/10.1366/0003702053945958
  16. G. Kim, W. Jo, H.-S. Ha, S. S Oh, D. Y. Park and H. Cheong, "Characterization of Co-Evaporated $SmBa_2Cu_3O_7$ Coated Conductors by Polarized-Raman Scattering Spectroscopy," IEEE Trans. Appl. Supercon., vol. 21, pp. 3352, 2011. https://doi.org/10.1109/TASC.2010.2089480
  17. G. Kim, H.-J. Jin and W. Jo, "Optical imaging methods for qualification of superconducting wires," Progress in Superconductivity and Cryogenics, vol. 16, pp. 21-24, 2014.